MHZ SOLIX Instrucciones De Manejo página 41

3.6 Deleting the end positions
1. With hand-held remote control units pull off the back cover to make the setting.
Caution: Keep battery gently pressed down (contact).
After making the setting, push the cover back on.
2. On the remote control unit press the P2 button once
=> Roller blind confirms with 1 beep + short movement.
3. On the remote control unit press the DOWN button once
=> Roller blind confirms with 1 beep + short movement.
4. On the remote control unit press the P2 button once
=> Roller blind confirms with beeps + short movement.
3.7 Logging a remote control unit off
i
Only remote control b can be logged off.
1. With hand-held remote control units pull off the back cover to make the setting.
Caution: Keep battery gently pressed down (contact).
After making the setting, push the cover back on.
2. On remote control unit a press the P2 button once
=> Roller blind confirms with 1 beep + short movement.
3. On remote control unit a press the P2 button once
=> Roller blind confirms with 1 beep + short movement.
4. On the remote control unit b press the P2 button once
=> Roller blind confirms with 5 beeps + short movement.
3.8 Resetting to factory settings using a paired hand-held
remote control
Delete all settings and all paired remote control units
1. With hand-held remote control units pull off the back cover to make the setting.
Caution: Keep battery gently pressed down (contact).
After making the setting, push the cover back on.
2. On the remote control unit press the P2 button once
=> Roller blind confirms with 1 beep + short movement.
3. On the remote control unit press the STOP button once
=> Roller blind confirms with 1 beep + short movement.
4. On the remote control unit press the P2 button once
=> Roller blind confirms with 5 beeps + short movement.
Edition 04.2022
Subject to technical changes I
3.9 Resetting to factory settings without a hand-held remote
control
Delete all settings and all paired remote control units
1. Keep the setting button on the drive unit pressed.
=> Roller blind confirms with short movements
P2
4 seconds apart + 4 beeps after release of the
setting button.
=> for programming again, see step 3.1
3.10 Limit number of channels
P2
Using these settings, it is possible to limit the remote control unit to the number
i
of channels that are actually needed for controlling the drive systems. Using
channel '0', all blinds are controlled.
1. On the remote control unit simultaneously press the
P1- and P1+ buttons.
=> the LCD display unit indicates 'C'.
a
P2
2. On the remote control unit keep the P1- and
P1+ buttons pressed.
a
=> the LCD display unit indicates '
P2 P2
b
3. On the remote control unit, press the P1- or P1+
P2
P2
button to select the number of channels. If, for
example, you are controlling only two drive units
with this remote control, select '
+
b b
a a
4. On the remote control unit press the STOP button
once.
=> the LCD display unit indicates ' '.
5. After a short time, limitation to two channels gets
indicated.
P2
i If you want to disable the additional 'Limit channel numbers' function, repeat
steps 1 to 5 and at step 3 increase the setting to '15'.
P2
Solix external roller blind
Adjustment instructions
(
applies only to 15-channel remote control units)
C
P1+
P1–
P1+
P1–
15
'.
15
2
'.
2
P1– P1+
2
DE
FR
C
15
NL
2
2
EN
ES
41
IT