Publicidad
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
Cleaner will
1. Unplugged at wall outlet.
1. Plug in firmly. Push ON-OFF
not run,
switch to ON.
2. ON-OFF switch not turned on.
. Push ON-OFF switch to ON.
3. Tripped thermal protector.
. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
- Tripped circuit breaker/olown
. Reset circuit breaker or replace
fuse at household service panel.
fuse.
Poor job of dirt
. Full or clogged dust bin.
. Empty dust bin.
pickup.
. Broken belt.
. Replace belt.
. Carpet-bare floor setting incorrect. | 3 . Set in the correct position.
. Clogged hose or nozzle.
. Clean hose or nozzle area.
. Hose not inserted fully.
. Insert hose.
. Worn agitator.
. Replace agitator.
. Hole in hose.
. Replace hose.
. Dust cover improperly installed.
. Properly install dust cover.
O 0 N TO
A Aa
Q N =
. Belt not installed on motor shaft.
. Install belt on motor shaft.
10, Floor cleaning attachment knob in] 10. Rotate valve knob to floor
the cleaning attachment position
position.
Light will
1. Burned out light bulb.
1. Replace light bulb.
not work.
Dirt sensor will
1. Dirty optic cells.
1. Clean optic cells.
1.
Performance
1. Full or clogged dust bin.
Clean dust bin.
indicator is red
:
2. Dirty filters.
. Clean/change filters
2
3. Clogged air flow passage
3. Remove clog from air flow passage
4
4. Certain attachment tools
. This is normal. Light should go off
when tool is removed: ~'
Publicidad
