Publicidad
EN
To use good quality pellets with dimensions and heat-producing properties other than those
recommended above, it will be necessary to change the stove operating parameters.
The use of cordwood is prohibited. Do not burn garbage or flammable fluids such as
gasoline, naphtha or engine oil.
This "customization" of stove settings must be carried outby authorized personnel by
distributor.
Using pellets that are out of date or not in conformity with the manufacturer's
recommendations not only damages the stove and jeopardizes its performance, but can
render the guarantee null and void and relieves the manufacturer of all liability.
6. Preparing for installation
To prevent accidents or damage to the product we recommend the following:
- unpacking and installation must be carried out by at least two people;
- every operation involving movement of the product must be carried out with the proper
tools in full compliance with current safety regulations;
- the packaged product must be kept in the position according to the directions shown by
the diagrams and notices on the pack;
- if ropes, straps or chains are used, ensure that they are able to take the weight of the pack
and that they are in good condition;
- never stand in the vicinity of loading/unloading equipment (forklift trucks, cranes etc.);
Unpack the product being careful not to damage or scratch it, take the accessories pack and
any pieces of polystyrene or cardboard used to wedge moveable parts etc. out of the stove
firebox. Keep packaging (plastic bags, polystyrene, etc.) out of reach of children, since it
could be a potential source of danger, and dispose of according to local regulations.
To make moving and handling of the stove easier for installation purposes, it is advisable to
remove the cladding in accordance with the procedure described in the paragraph
"removing the cladding" and then refit it upon completion of installation. If you decide to
install the stove without removing the cladding, take great care not to buckle, scratch or in
any way damage the bottom of the side panels and the lower front panel.
Installation and assembly of the stove must be carried out by qualified personnel.
7. Use
The pellet stove is a different type of heater. Its operation and maintenance differ from the
traditional wood stove. Follow these operating instructions exactly as stated to ensure safe
and reliable operation.
• Do not use the stove as a cooking appliance.
• Ensurethattheroominwhichthestoveisinstalledissufficientlywellventilated(freshairintake).
• A certain amount of carbon monoxide may be produced within the stove as a by-product
of combustion. All exhaust vent connections must be sealed with RTV silicone to assure a gas
tight seal. Any leaks into a confined area caused by faulty installation or improper operation
of the stove could produce dizziness, nausea and in extreme cases, death.
• Check (or have checked) regularly that the flue is clean.
• Under no circumstances use fuels other than pellets.
• Remove any deposits of unused pellets left by failed ignition before restarting the stove.
Publicidad
