Publicidad
Warning!
Direct contact with the stove while operating may cause skin burns.
During operation some parts of the stove (door, handle, controls, ceramic parts) can reach
high temperatures. Take great care and all the necessary precautions, especially in the
presence of children, the elderly or disabled and pets.
Keep any inflammable object well away from the stove while it is in use (MINIMUM 32"-80
cm) from the front panel. While in use the door must remain closed and the glass must be
present and intact.
The removal of the protective grille inside the pellet hopper is strictly prohibited.
If replenishing with pellets while the stove is lit, ensure that the bag does not come into
contact with any hot surfaces.
Operate this unit only with the fuel hopper lid closed. Failure to do so may result in emission
of products of combustion from the hopper
under certain conditions. Maintain hopper seal in good condition.
Loading the pellets
When lighting your stove for the first time, or any time you have run out of Pellets, you will
need to fill the hopper. Pellets are fed from the hopper to the burn pot by an auger. A high
torque motor that is capable of doing serious harm to fingers drives the auger and for this
reason in the pellet stoves a protective grille inside the hopper is placed.
Don't remove the protective grill inside the pellet hopper.
To load the pellets into the hopper it is advisable to tear off the edge of the sack and empty
the sack directly into the hopper. This makes filling easier and avoids pouring pellets on top
of the stove.
Warning!
• Do not allow sawdust to accumulate on the bottom of the hopper.
• Do not leave leftover pellets on top of the stove – they could catch fire!
• Do not overfill hopper.
• Maintain hopper seal in good condition.
• Do not reload with pellets when the appliance is lit if the red reload indicator inside
the pellet hopper is visible (see figure to the side).
To load with pellets if the red reload indicator is visible, proceed as follows:
• shut down the appliance,
• load the hopper as described above. The auger must have the time to fill;
• during this stage the pellets are not distributed inside the firebox and it is more than
likely that the first attempt to ignite the appliance fails;
• empty and clean the great. Lighting again the stove.
EN
Publicidad
