Worx WG300 Manual Del Usuario página 13

(19) prior t ostarting and regularly during
operation. Refill oilwhen o illevel islow.The
oiltank filling willlast a pprox. 16minutes,
depending onsawing intensity and stops.
(Fig. G2)
Check new replaced chain t ension approx.
every 1 0 minutes during o peration.
1.Connect saw toextension cord. Connect
extension cord topower supply.
2. Make s ure section oflog tobecutisnot
laying o nground.This willkeep c hain f rom
touching ground a s itcuts t hrough log.
Touching ground withmoving chain w ill
dull c hain.
3. Use both hands togrip saw. Always use
lefthand t ogrip front h andle and right
hand t ogrip rear h andle. Use firmgrip.
Thumbs and fingers m ust wrap around
saw handles.(See Fig.H)
4. Make s ure your f ooting i sfirm. K eep f eet
apart. Divide y our w eight evenly onboth
feet.
5. When r eady t omake a cut, p ush t helock-
offbutton c ompletely forward with the
right t humb a nd squeeze the trigger.This
willturn saw on.Releasing trigger will t urn
saw off. M ake s ure saw isrunning atfull
speed before starting acut.
6. When s tarting acut, p lace m oving chain
against wood. Hold saw firmly inplace
toavoid p ossible bouncing orskating
(sideways movement) ofsaw.
7. Guide saw using l ight p ressure. Donot
force s aw.The motor will o verload and can
burn out. I twilldothe jobbetter and safer
attherate forwhich i twas intended.
8. Remove saw from acut w ithsaw running
atfullspeed. Stop saw byreleasing trigger.
Make s ure chain h as s topped before
setting saw down.
9. Practice until youcan maintain asteady,
even c utting r ate.
KICKBACK SAFLrlrY DIL_II|CES ON THiS
SAW
This saw has a low-kickback chain and
reduced kickback chain bar. Both items reduce
the chance of kickback. Kickback can still occur
with this saw.
The following steps will reduce the risk of
kickback.
* Use both hands to grip saw while saw is
running. Use firm grip.Thumbs and fingers
must wrap around saw handles.
* Keep all safety items in place on saw.
Make sure they work properly.
* Do not overreach or cut above shoulder
height.
* Keep solid footing and balance at all times.
* Stand slightly to left side of saw.This keeps
your body from being in direct line with
chain.
* Do not let guide bar nose touch anything
when chain is moving.
* Never try cutting through two logs at same
time. Only cut one log at a time.
* Do not bury guide bar nose or try plunge
cut (boring into wood using guide bar
nose).
* Watch for shifting of wood or other forces
that may pinch chain.
* Use extreme caution when reentering a
previous cut.
* Use low-kickback chain and guide bar
supplied with this chain saw.
* Never use dull or loose chain. Keep chain
sharp with proper tension.
GEN E|_t, IL BEHAVIOR
Use the chain saw only with secure footing.
Hold the chain saw at the right-hand side of
your body. (See Fig. I)
The chain must be running at full speed
before it makes contact with the wood. Use
the metal gripping teeth to secure the saw
onto the wood before starting to cut. Use the
gripping teeth as a leverage point "a" while
cutting. (See Fig. J)
Do not operate the chain saw with arms fully
extended or attempt to saw areas which are
difficult to reach, or on a ladder. Never use the
chain saw above shoulder height.
(See Fig. K)