Worx WG300 Manual Del Usuario página 15

as illustrated, cut 1/3 the diameter from
the underside (underbuck).Then make the
finished cut by overbucMng to meet the first
cut. (See Fig. P)
When the log is supported on both ends,
as illustrated, cut 2/3 the diameter from the
top overbuck.Then make the finished cut by
underbucking the lower 1/3 to meet the first
cut. (See Fig. Q)
_ WARN|NG: (See Fig. R)
o If o, slope, make sure log will ,or
roU dew, hill Secure log by using
woode, stakes. Driwe woode, stakes
into ground on downhW side of log.
Stand on uphill side of log while
cutting. Log may roll after cutting.
o Never try cutting through two logs
at same time. This could increase the
risk of kickback.
o _ile cutting log, ,,ever hold log with
your hand, leg, or foot.
o _ile cutting log, never allow another
person to how log.
o Turn off and unplug saw before
moving from one place to another.
SAW MAINTENANCE
AND
KICKBACK 5AFE
Follow maintenance instructions in this
manual. Proper cleaning of saw and chain and
guide bar maintenance can reduce chances of
kickback, inspect and maintain saw after each
use.This will increase the service life of your
saw.
NOTE: Even with proper sharpening, risk of
kickback can increase with each sharpening.
MAINTENANCE
AMD
STORAGE OF CflAIN SAN
1. Unplug chain saw from power source
* When not in use
* Before moving from one place to another
* Before servicing
* Before changing accessories or
attachments, such as saw chain and guard
2. inspect chain saw before and after each
use. Check saw closely if guard or other part
has been damaged. Check for any damage
that may affect operator safety or operation
of saw. Check for alignment or binding of
moving parts. Check for broken or damaged
parts. Do not use chain saw if damage affects
safety or operation. Have damage repaired by
authorized service center.
3. Maintain chain saw with care.
o Never expose saw to rain.
o Keep chain sharp, clean, and lubricated for
better and safer performance.
o Follow steps outlined in this manual to
sharpen chain.
o Keep handles dry, clean, and free of oil and
grease.
o Keep all screws and nuts tight.
* Inspect power cord often. If damaged,
have repaired by authorized service center.
* Never carry chain saw by power cord.
* Never yank power cord to unplug it.
* Keep power cord from heat, oil, and sharp
edges.
* Inspect extension cords often and replace
if damaged.
4.When servicing, use only identical
replacement parts.
5.When not in use, always store chain saw
* In a high or locked place, out of children's
reach
* In a dry place
l!|eplacing Saw Chain/chain bar
Replace chain when cutters are too worn
to sharpen or when chain breaks. Only use
replacement chain noted in this manual.
Always include new drive sprocket when
replacing chain.This will maintain proper
driving of chain.
inspect guide bar before sharpening chain. A
worn or damaged guide bar is unsafe. Aworn
or damaged guide bar will damage chain. It
will also make cutting harder.
Fit the tensioning catch into the new bar by
tightening the screw clockwise.The catch