Publicidad
Idiomas disponibles
Idiomas disponibles
SETTINGS
If you switch wires (e.g. between antenna and
CATV) or if you move the TV to a different area
after the initial setting, you need to perform
Autoscan again. This function lets you easily select
the receivable channels with ION A/T] and the TV
memorizes them even if you switch wires.
NOTE:
* Make sure if the TV is connected
to antenna or cable.
"1 Display the setup screen.
. Press [SETUP].
The following setup screen is displayed.
3
For TV channels, using [A/_'], select "Air".
For CATV channels, select "Cable".
. Press [ENTER].
Scanning and memorizing the channels auto-
matically starts.
. When the scanning and memorizing are com-
pleted, the memorized smallest channel in the
broadcasting will be displayed.
NOTES:
I
If you press
[POWER]
or [SETUP]
during Autoscan,
this I
setting
will be canceled.
I
* tf there is no reception
connected
or poor signal is detected,
a Hint will appear on screen once scanning
stops.
09
(5
z
I--
I--
LU
09
=J
uJ
z
z
o
(5
..J
=J
09
2
Select "CHANNEl"
and press [ENTER] to con-
firm.
* Using [A/_],
select "Autoscan".
• Press [ENTER].
EN
Publicidad
