Publicidad
Idiomas disponibles
Idiomas disponibles
TV
You can select the channel by using either [CH A/T]
or Channel number buttons. How to select the
channel in each way is shown below.
ii® ® @
ii® ®
1 Using [OH A/T] or Channel number
buttons,
and pressing [ENTER].
• Using [OH A/_'], change the channel.
. When you select a channel press the channel
number you want to view with Channel number
buttons. The selected channel will be displayed.
. When selecting analog channel 12
NTSC
ATSC
18:00
18:30
19:00
19:30
20:00
: changes automatically
=> : change manually by pressing [CHA/v]
on your remote control.
NOTE:
"No signal" will appear on the screen after the minor-
channel broadcast is over.
You will need to change the channel to continue
watching another TV program.
USTMEN
This section describes how to adjust the volume
when viewing TV. The MUTE function, which is use-
ful when you have a visitor or a phone call, will be
also described.
• When selecting digital channel 12-1
Be sure to press [-] before entering the
minor-channel number.
• If the channel broadcasts NTSC and ATSC both
and you don't press H, then you will receive the
NTSC channel only. The moment you press [-],
the memorized smallest digital channel will be
displayed.
• When you press [OH RETURN], the previously
selected channel will be selected.
. Same operation is available with [CHANNEL
A/'_'] on the top panel of the main unit.
NOTE:
]
tn the D TV broadcasting,
one channel sometimes
broadcasts
I
multiple programs
depending on the air time. tn this case, the I
main channel is called major channel and the minor-channel
I
is called minor channel.
J
About minor-channel
broadcasting:
There may be different programs being broad-
cast on minor-channels
through a single chan-
nel from ATSC. You can watch each minor-
channel program being broadcast by selecting
one of the minor-channels.
1 Using [VOL A/q]
or [MUTE]
[VOL Afv]
. You can adjust the audio volume with [VOL A/V].
. The volume bar is displayed at the bottom of
the screen when adjusting the volume.
. Same operation is available with [VOLUME
A/V] on the top panel of the main unit.
• The volume bar display will automatically
dis-
appear in a few seconds.
[MUTE]
• Press [MUTE] on the remote control to mute
the sound.
. To release the Mute status, press [MUTE[
again or press [VOL A/V].
. "Mute" is displayed on the screen for a few sec-
onds.
EN
Publicidad
