Human Touch SUPER NOVO 2.0 Manual De Uso Y Cuidado página 6

get acquainted
USING THE REMOTE CONTROL
The status screen displays during your massage, providing a quick reference for the following information. This
handy display not only shows the current status for each of the settings, but allows you to configure the settings
indicated below in orange. Use the up/down navigation buttons to toggle through the settings, use the right/left
buttons to adjust them, then use the center navigation ring button to make your selection. NOTE: If a setting is
grayed out, that setting is not adjustable during the current massage.
MSG SPD — In manual mode, the
Kneading, Tap Touch, Percussion, or
Knead & Percuss speed
CLDINTSTY — The Cloud Touch intensity
(Cloud Touch must be active to set the
intensity)
UNDFTSPD — The underfoot roller speed
(rollers must be on to set the speed)
WIDTH — In manual mode, the Tap
Touch, Percussion, or Shiatsu horizontal
massage range
INTSTY — The back massage intensity
(not configurable during Meditation
programs)
The amount of time remaining in
the current massage session
Illustrates the areas currently
being massaged
humantouch.com
The active massage program
Lights blue when Bluetooth is set to ON
Lights blue when chair is in ZeroG
The active robotic massage technique
Vertical massage range indicator:
- Full
- Zone
- Spot
Super Novo 2.0
Lights red if Heat is ON
8 8
MENU — Press to display the
main menu. When a massage
is in progress, press again to
display the status screen.
PROGRAMS — Displays the
PROGRAMS menu. When
position
®
an auto program is running,
press to toggle among the
auto programs. The active
program displays at the top of
the status screen.
CLOUD — When the status
screen is displayed, press
to adjust the Cloud Touch
intensity. The selected intensity
displays in the upper left-hand
corner of the screen.
BACK — Press and hold to
recline or incline the backrest.
LEGS EXTEND — Press and hold
to extend the footrest.
NOTE: During auto programs,
the chair automatically measures
your legs and adjusts the
program accordingly.
POWER / PAUSE / RESTORE
Press this button:
• To power on the remote.
• To pause the massage and display the
following options:
RESUME - select to resume the massage
where you left off.
POWER OFF - select to stop all functions and
restore the chair to the upright position before exiting.
Press the up/down/left/right buttons to navigate the
screens; press the center button to select an option.
Super Novo 2.0
POSITION — Use to:
• Adjust the vertical massage range after AcuPoint
Body Sensing.
• Adjust the vertical massage range during an auto
massage program. See Adjusting Vertical Massage
Range on page 31.
• Move the massage rollers to the desired position
when enjoying a Zone or Spot massage. See
Using Manual Massage Modes on page 18 for
more information. NOTE: When pressed during a
manual massage, sets the vertical massage range
to Spot.
HEAT — Press to toggle the backrest and footrest
Heat ON and OFF.
LEGS — Press and hold to raise or lower the footrest.
ZeroG — Press to automatically position the chair
®
in zero gravity, raising your feet above your heart for
maximum spine relief.
LEGS RETRACT — Press and hold to retract the
footrest.
If the chair is not in use for three minutes the
controller display automatically shuts down.
Press the POWER / PAUSE / RESTORE button
to resume use.
9