Publicidad
Idiomas disponibles
Idiomas disponibles
Before
You Call (cont.)
............................................
Stops
Leaks water
Is noisy
Fills with
the wrong
tem-
perature
water
• Unevenly
distributed
load. Redistribute
the load, close the lid and pull knob
out. Check for leveling. Be sure water level is acceptable
for load size.
• Plug cord into live electrical outlet.
• Check fuse or reset circuit breaker.
• Turn the control knob to proper cycle and pull knob out to start the washer.
• Close lid and pull knob out to start the washer. For your safety, washer will not
agitate or spin unless lid is closed.
• This may be a pause or soak period in the cycle. Wait briefly and it may start.
• The washer
is equipped
with a lid switch failure detector. If the lid switch
should malfunction,
the detector will stop fill operations
for your safely. Call
for service.
• Make sure hose connections
are tight.
• Make sure end of drain hose is correctly inserted and secured to drain facility.
• Avoid extended
soaking - soak for 30 minutes or less.
• Avoid overloading.
• Be sure washer is leveled properly as outlined in installation
manual.
• Weak floors can cause vibration
and walking.
• Be sure rubber feet are installed on leveling legs.
• Operating
sounds will vary depending
on agitation speed.
• Turn both faucets on fully.
• If equipped
with a temperature
selector knob, be sure it is set directly on a
temperature
setting and not between settings.
• Make sure temperature
selection is correct.
• Make sure hoses are connected
to correct faucets and inlet connections.
Be
sure water
supply
is regulated
correctly.
Flush
water
line before
filling
washer.
• Check the water heater. It should be set to deliver a minimum
120°F (49°C)
hot water at the tap. Also check water heater capacity
and recovery
rate.
• Disconnect
hoses and clean screens. Hose filter screens may be plugged.
9
Publicidad
