Publicidad
Idiomas disponibles
Idiomas disponibles
Care and Cleaning .................................................
Turn off the water t:aucets after finishing the day's wash-
ing. This will shut off the water supply to the washer and
prevent the unlikely
possibility
of damage
from escap-
ing water.
Use a soft cloth to wipe up all detergent, bleach or other
spills as they occur.
Clean the following
as recommended:
Control
Panel - clean with a soft, damp cloth and glass
cleaner.
Do not use abrasive
powders
or cleaning
pads.
Cabinet
- clean with soap and water followed
with an
appliance
wax, if desired.
Fabric
Softener
Dispenser
1. Pull the dispenser
off of the top of the agitator.
2. Soak
for one hour
in sink or container
in hot
water and dishwashing
liquid.
3. Hold hands over top and bottom
of dispenser
and
shake to loosen buildup.
4. Rinse with clean, hot water.._,_-,.
5. Repeat process
if necessary.
6. Replace dispenser
on agitator.
Do
not
use
dishwashing
liquid
inside the washer. Oversudsing
can
Occur.
Interior
- hard water deposits may be removed,
if need-
ed, using
a recommended
cleaner
labeled
washer
sate.
Lint Filter
- it is self-cleaning
and requires no mainte-
nance. The filter is located under the agitator
on the
bottom
of the washtub.
During
the wash and rinse
portion
of
the
cycle, lint is col-
lected on the fil-
ter. Then
during
the
spin
and
drain the filter is
cleaned
automat-
ically.
Storing
the Washer ..............................................
Washers can be damaged
if water is not removed
from
hoses and internal
components
before
storage.
Prepare
the washer
for storage as follows:
Select NORMAL
on the REGULAR
cycle and add
•
one cup of bleach
OR white vinegar to a full load of
water without
clothes. (Do not mix bleach
and vine-
gar in the same wash. Hazardous
fumes can form.)
•
Run the washer through a complete
cycle.
• Turn the water
faucets
off and disconnect
the inlet
hoses.
Disconnect
the washer
from the electrical
supply and
leave the washer lid open to let air circulate inside the
tub.
If the washer has been stored in below-freezing
tem-
peratures,
allow time for the washer to thaw out prior
to use.
After storage,
select
NORMAL
on the REGULAR
cycle and run the washer through a complete
cycle.
7
Publicidad
