Publicidad
Idiomas disponibles
Idiomas disponibles
HYDRA X
4
OPERATION
This equipment produces a fluid stream at
extremely high pressure. Read and understand
the warnings in the Safety Precautions section
at the front of this manual before operating this
equipment.
4.1
SETUP
1. Turn the master power switch ON (I).
2. Press and hold the 'UP' (G) on the lift switch for three
seconds to raise the hydraulic motor/fluid pump assembly.
Release the switch after three seconds and the lift wil
automatically raise to its highest position and then stop.
3. Open (pull apart) the two brass clasps on the top of the
suction tube assembly (Fig. 5, item 1).
4. Mount the suction tube (2) over the fluid pump (3).
5. Close the two clasps to secure the suction tube. Insert
the locking clips (not shown) to lock the coupler clasps in
place.
3
1
2
6. Make sure the bleed hose (Fig. 6, item 1) is threaded into
the bleed valve (2). It has factory installed blue thread
locker on the fitting and should be tightened wrench tight.
7. Attach a minimum of 50' (15 m) of nylon airless spray hose
(3) to the sprayer. Do not use PTFE tape or thread sealant
on the spray hose connection.
8. Attach an airless spray gun to the spray hose. Do not
attach the tip to the spray gun yet. Remove the tip if it is
already attached.
i
9. Fill the oil cup 1/2 full with Piston Lube (P/N 314-480).
This extends packing life. When using silicone, use part
number 91-36, throat seal lubricant.
Attention
10. Check the hydraulic fluid level daily before starting the
sprayer. The hydraulic fluid level should be between the
two notches on the dipstick. Refer to the Maintenance
section of this manual for hydraulic system maintenance
instructions.
2
Attention
11. Check the engine oil level daily before starting the sprayer.
The gasoline engine oil level is determined by the engine
manufacturer. Refer to the engine manufacturer's service
3
1
manual supplied with this sprayer.
For multiple gun operation, connect the multiple
gun manifold to the single gun outlet (see
manifold kit 2414176 for details). Connect a hose
and gun to the desired number of outlets. Make
sure the unused gun outlets remain plugged.
See "Technical Data", Section 3.5 to determine
number of guns and maximum spray tip sizes.
Piston Lube prevents increased wear and tear to
the packings.
Use of Titan's Coolflo™ Hydraulic Fluid (P/N 430-
361) is mandatory in the hydraulic system. Do
not use any other hydraulic fluid. Use of any
other hydraulic fluid may seriously damage the
hydraulic system and will void the warranty.
OPERATION
13
Publicidad
