Pioneer AVH-Z9250BT Manual De Instrucciones página 43

Menu Item Description
[Dimmer Duration] Adjust the time that the dimmer is turned on or off by
dragging the cursors or touching
You can use this function when [Dimmer Trigger] is set to
[Time].
TIPS
• Each touch of
forwards in the 15 minute width.
• When the cursors are placed on the same point, the dimmer
available time is 0 hours.
• When the cursor for off time setting is placed on the left end and
the cursor for on time setting is placed on the right end, the
dimmer available time is 0 hours.
• When the cursor for on time setting is placed on the left end and
the cursor for off time setting is placed on the right end, the
dimmer available time is 24 hours.
NOTE
The time display of the dimmer duration adjusting bar depends on
the clock display setting (page 51).
[Picture Adjustment]
You can adjust the picture for each source and rear view camera.
CAUTION
For safety reasons, you cannot use some of these functions while your vehicle is in motion. To enable
these functions, you must stop in a safe place and apply the handbrake.
To adjust following menu, touch ,
Menu Item Description
[Brightness] Adjust the black intensity.
[-24] to [+24]
[Contrast] Adjust the contrast.
[-24] to [+24]
[Colour]* Adjust the colour saturation.
[-24] to [+24]
[Hue]* Adjust the tone of colour (which colour is emphasised, red,
[-24] to [+24] or green).
[Dimmer Level] Adjust the brightness of the display.
[+1] to [+48]
[Temperature] Adjust the colour temperature, resulting in a better white
[-3] to [+3] balance.
or .
or moves the cursor backwards or
, , to adjust.
* With some pictures, you cannot adjust [Hue] and [Colour].
NOTES
• The adjustments of [Brightness], [Contrast], and [Dimmer Level] are stored separately when your
vehicle's headlights are off (daytime) and on (nighttime).
• [Brightness] and [Contrast] are switched automatically depending on the setting of [Dimmer
Settings].
• [Dimmer Level] can be changed the setting or the time to switch it to on or off (page 42).
• The picture adjustment may not be available with some rear view cameras.
• The setting contents can be memorised separately.
[System Information]
Menu Item Description
[Firmware Information] Displays the firmware version.
TIP
You can also check the open source licence of the functions that
this product is equipped with by touching [Licence] in this menu.
[Firmware Update]
CAUTION
• The external storage device for updating must contain only the
correct update file.
• Never turn this product off, eject the SD memory card or
disconnect the USB storage device while the firmware is being
updated.
• You can only update the firmware when the vehicle is stopped
and the handbrake is engaged.
• You cannot update the old firmware version once the latest
firmware is updated.
1
Download the firmware update files into your
computer.
2
Connect a blank (formatted) storage device to your
computer then locate the correct update file and copy
it onto the USB storage device.
3
Set the external storage device to this product
(page 25).
4
Turn the source off (page 18).
5
Display the [System] setting screen (page 39).
6
Touch [System Information].
7
Touch [Firmware Update].
8
Touch [Continue].
Follow the on-screen instructions to finish updating the
firmware.
NOTE
If an error message appears on the screen, touch the display and
perform the above steps again.
43
En