Metabo C 12RSH3 Manual página 16

English
6 mm depth adjustment bolt
Hinge
8 mm depth
adjustment bolt
Turntabe
3. Lower limit position of saw blade when cutting a large
workpiece
When cutting a workpiece 4-7/32" (107 mm) to
4-11/16" (120 mm) in height in right-angle cutting or
2-3/4" (70 mm) to 2-15/16 (75 mm) in left bevel angle
cutting or 1-3/4" (45 mm) to 1-15/16 (50 mm) in right
bevel angle cutting, adjust the lower limit position so
that the base of the motor head (see Fig. 10-a) will not
come in contact with the workpiece.
NOTE
Confirm that the saw blade is adjusted so that it will
not cut into the turntable.
Lower the motor head, and turn the 6 mm depth
adjustment bolt and make adjustments so that there can
be a clearance of 5/64" to 1/8" (2 mm to 3 mm) between
the lower limit position of the motor head and the top of the
workpiece at the saw blade's lower limit position where the
head of the 6 mm depth adjustment bolt contacts the
hinge. (Fig. 10-b)
Turn
Hinge
16
Moror head
Gear case
Saw blade
Fig. 10-a
Gear case
6 mm depth adjustment bolt
Fig. 10-b
Bottom surface of head section
2–3 mm
Workpiece
4. Confirmation for use of sub fence (A)
WARNING
When right bevel angle cutting, loosen the 6 mm
wing bolt, then slide the sub fence (A) outward
and remove it as shown in Fig. 11.
Failure to do so may result in the main body or
saw blade coming into contact with the sub
fence (A) and causing injury.
This power tool is equipped with a sub fence (A). In
the case of direct angle cutting and left bevel angle
cutting, use the sub fence (A). Then, you can realize
stable cutting of the material with a wide back face.
CAUTION
In the case of direct angle cutting and left bevel
angle cutting, slide inward to the position where
the sub fence (A) hits, and secure it with 6 mm
wing bolt. (as shown in Fig. 11)
Mounting position of
the sub fence (A)
6 mm wing bolt
Fig. 10-c
Sub fence (A)
Fence (A)
Fig. 11