Metabo C 12RSH3 Manual página 20

English
Adjusting miter angles:
(1) Push up the miter lock handle to release the turntable.
(2) Push down the positive stop lever until the detent
lever catches on it to release the "positive stop".
(3) Rotate the turntable and set the indicator to line up
with the desired angle of the miter scale. At this time,
when using the positive stop function, pull the detent
lever in the direction of the arrow near the desired
angle as shown in Fig. 19, release the detent lever,
and move the turntable to secure it in place at the
desired angle via the positive stop function. (0°, 15°,
22.5°, 31.6°, and 45°)
(4) Push down the miter lock handle to secure the
turntable in place.
Detent lever (Fig. 19)
The detent lever allows for the table to be micro adjusted,
disengaging the positive detent stops feature. When a
required miter angle is close to a positive detent stop, this
detent lever prevents the wedge on the positive stop lever
from slipping into that detent slot on the base.
14. LED lighting system (Fig. 20) [XACT CUT LED™]
CAUTION
Do not stare at operating lamp. Staring into the
light beam may result in serious injury or vision
loss.
The LED lighting system [XACT CUT LED™] casts the
shadow of the blade onto the workpiece. This results in
greater accuracy of cuts and requires no adjustments.
The LED light will light up just by plugging the power plug
in to the outlet.
Bring the motor head down so the blade is approximately
1/4 in. (6 mm) from the workpiece. The shadow of the
blade will be projected onto the workpiece, indicating
where the blade teeth will make contact as the cut is
made.
To turn the LED light off, unplug the power plug from the
outlet.
20
Shadow of blade teeth projected onto workpiece
PRACTICAL APPLICATIONS
WARNING
● To avoid personal injury, never remove or place
a workpiece on the table while the tool is being
operated.
● Never place your limbs inside of the line next to
warning sign while the tool is being operated.
This may cause hazardous conditions.
Line
Warning sign
1. Switch operation
The tool will not start unless the Lock-off button is
pressed while the switch is pulled back.
The Lock-off button can be engaged by pressing it
from the left.
Fig. 20
Line
Warning sign
Fig. 21