Publicidad
Idiomas disponibles
Idiomas disponibles
English
Type of Crown Molding
To process crown molding at positions ① and ④ in
Fig. 34.
Miter Angle Setting
Bevel Angle Setting
To process crown molding at positions ② and ③ in
Fig. 34.
Miter Angle Setting
Bevel Angle Setting
(1) Setting to cut crown moldings at positions ① and ④
in Fig. 34 (see Fig. 35; tilt the motor head to the left):
○ Turn the turntable to the right and set the Miter Angle
as follows:
–
For 45° type crown moldings: 35.3° ( mark)
–
For 38° type crown moldings: 31.6° ( mark)
○ Tilt the motor head to the left and set the Bevel Angle
as follows:
–
For 45° type crown moldings: 30° ( mark)
–
For 38° type crown moldings: 33.9° ( mark)
○ Position the crown molding so that the upper surface
(Ⓐ in Fig. 33) contacts the fence as indicated in
Fig. 37.
(2) Setting to cut crown moldings at positions ② and ③
in Fig. 34 (see Fig. 36; tilt the head to the left):
○ Turn the turntable to the left and set the Miter Angle
as follows:
–
For 45° type crown moldings: 35.3° ( mark)
–
For 38° type crown moldings: 31.6° ( mark)
○ Tilt the head to the left and set the Bevel Angle as
follows:
–
For 45° type crown moldings: 30° ( mark)
–
For 38° type crown moldings: 33.9° ( mark)
26
Table 3
45° Type
38° Type
right 35.3°
right 31.6°
( mark)
( mark)
left 30°
left 33.9°
( mark)
( mark)
left 35.3°
left 31.6°
( mark)
( mark)
left 30°
left 33.9°
( mark)
( mark)
○ Position the crown molding so that the lower surface
(Ⓑ in Fig. 33) contacts the fence as in Fig. 38.
Head
①
①
Miter angle
scale
Turntable
Head
Fence (B)
②
②
Turntable
Fence
Ⓐ
Bevel angle
scale
Fence (A)
④
④
Base
Fig. 35
Bevel angle
scale
③
③
Miter angle
Base
scale
Fig. 36
Ⓑ
Table on base
Fig. 37
Publicidad
