Metabo C 12RSH3 Manual página 12

English
APPLICATIONS
○ Cutting various types of wood.
○ Cutting aluminum sash.
PREPARATION BEFORE OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power source requirements specified on the
product nameplate.
2. Power switch
Ensure that the switch is in the OFF position. If the
plug is connected to a receptacle while the switch is
in the ON position, the power tool will start operating
immediately and can cause serious injury.
3. Extension cord
When the work area is far away from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
WARNING
Damaged cord must be replaced or repaired.
4. Remove all packing materials attached or connected
to the tool before attempting to operate it.
5. Installation
Attach the power tool to a level, horizontal work bench
in accordance with Fig. 4.
Select 5/16" (8 mm) diameter bolts suitable in length
for the thickness of the work bench. Bolt length
should be at least 1-9/16" (40 mm) plus the thickness
of the work bench.
For example, use 2-9/16" (65 mm) or larger bolts for a
1" (25 mm) thick work bench.
12
ASSEMBLY AND OPERATION
11/32" (9 mm)
4 holes
12-7/8"
(327 mm)
Miter lock handle side
Base
5/16" (8mm) bolt
Work bench
The holder attached to the rear of the base helps stabilize
the power tool.
Holder adjustment:
Loosen the 6 mm bolt with the 10 mm box wrench.
Adjust the holder until its bottom surface contacts the work
bench surface.
After adjustment, firmly tighten the 6 mm bolt.
11-1/18"
(282 mm)
5/16" (8 mm) nut
Fig. 4