Publicidad
Idiomas disponibles
Idiomas disponibles
Holder
Adjust the holder until its bottom surface
contacts the work bench surface.
6. Releasing the locking pin
When the power tool is prepared for shipping, its main
parts are secured by a locking pin.
Press the handle slightly down and pull out the
locking pin to disengag the cutting head.
During transport, lock the locking pin into the gear
case.
Locking pin
Pull
2
7. Installing the dust bag, side holder, stopper and vises
(The stopper is an optional accessory.)
To empty the dust bag, pull out the dust bag
assembly from dust port. Open zipper on underside of
bag and empty into waste container. Check
frequently and empty the dust bag before it gets
full.
When bevel angle cutting, adjust the support bar and
install the dust bag so that it hangs down vertically.
Move
6 mm Bolt
Fig. 5
Handle
Fig. 6
Dust bag
Vertical
WARNING
Do not use this saw to cut and/or sand metals.
The hot chips or sparks may ignite saw dust
from the bag material.
CAUTION
● Empty the dust bag frequently to prevent the
duct and the lower guard from becoming
clogged.
Sawdust will accumulate more quickly than
normal during bevel cutting.
● After cutting wood, before starting to cut
aluminum sash, discard the chips that are in the
dust bag.
1
(Attach the vise assembly as shown in Fig. 2, Fig. 3 and
Fig. 23.)
BEFORE USING
WARNING
Check steps 1 through 10 before you have
installed the power supply to the tool.
1. Make sure the power source is appropriate for the
tool.
WARNING
Never connect the power tool unless the
available AC power source is of the same voltage
as that specified on the nameplate of the tool.
Never connect this power tool to a DC power
source.
English
Support bar
Dust port
Gear case
Fig. 7
13
Publicidad
