Publicidad
Idiomas disponibles
Idiomas disponibles
English
13. Connecting the dust extractor (Sold separately)
(Fig. 47)
Do not inhale the harmful dusts generated in cutting
operation.
The dust can endanger the health of yourself and
bystanders.
Use of dust extractor can reduce dust related
hazards.
By connecting with dust extractor through adapter,
joint and dust collection adapter, most of dust can be
collected.
Connect the dust extractor with adapter.
(1) Connect in order of hose (id 38 mm x 3 m long) and
adapter*
2
, joint (C)*
with the duct of power tool.
Connection is done by pressing in the direction of the
arrow. (Fig. 47)
The dust collection adapter*
hose band*
1
.
*1 Optional accessory
*2 Dust extractor's standard accessory
Dust extractor
Hose (id 38 mm)
Dust collection adapter*
Adapter*
2
1
Joint (C)*
Hose band*
OPTIONAL ACCESSORIES...sold separately
○ Joint (C) (Code No. 337526)
○ Dust collection adapter (with hose band) (Code No.
376291)
30
1
and dust collection adapter*
1
is fixed to the duct by a
1
1
Duct
Fig. 47
SAW BLADE MOUNTING AND
DISMOUNTING
WARNING
● To prevent an accident or personal injury, always
turn off the trigger switch and disconnect the
power plug from the receptacle before removing
or installing a saw blade. If cutting work is done
in a state where the 10 mm bolt is not sufficiently
tightened, the 10 mm bolt can get loose, the
blade can come off, and the lower guard can get
damaged, resulting in injuries. Also, check that
the 10 mm bolts are properly tightened before
plugging the power plug into the receptacle.
1
● If the 10 mm bolts are attached or detached
using tools other than the 8 mm hex. bar wrench
(standard accessory), excessive or improperly
tightening occurs, resulting in injury.
1. Mounting the saw blade
(1) Press in spindle lock and loosen 10 mm bolt with
8 mm hex. bar wrench (standard accessory).
Since the 10 mm bolt is left-hand threaded, loosen by
turning it to the right as shown in Fig. 48-a, Fig. 48-b.
NOTE
If the spindle lock cannot be easily pressed in to lock
the spindle, turn the 10 mm bolt with 8 mm hex. bar
wrench (standard accessory) while applying pressure
on the spindle lock.
The saw blade spindle is locked when the spindle
lock is pressed inward.
(2) Remove the bolt and washer (B)
Spindle lock
Fig. 48-a
Publicidad
