Descargar Imprimir esta página

Pando PVMB 15-7CR Manual De Uso E Instalación página 193

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Pando
Pando
Pando
Vibrations.
The device
seems to make
too much noise.
The door does
not close
properly.
The display
shows E0, E1,
E2, E3, E4, E5,
E6, E7, E8, E9,
Ec or Et.
The
alarm
sounds and the
temperature
indicator is NOT
flashing (alarm
door).
The alarm
sounds AND the
temperature
display flashes
(temperature
alarm).
Integralcooking
Integralcooking
• The appliance is not properly levelled.
The rattling noise may come from the refrigerant flow, which is normal. At the
end of each cycle, you may hear gurgling noises caused by the flow of refrigerant
If temperature fluctuations occur, the contraction and expansion of the interior
walls can cause popping and creaking noises.
• The appliance is not properly levelled.
• The appliance is not properly levelled.
• The door was reversed and not
reinstalled correctly.
• The gasket is dirty.
• The shelves are out of position.
• Error code.
The door has been left open for more than
60 seconds.
• Has the appliance door been open for
more than 60 seconds? If not, then the
temperature has risen or fallen above
the temperature that has been set. This
could be due to:
-
The appliance door opens too
often.
-
The
ventilation
clogged or too dusty.
-
A prolonged power outage.
- A large amount of bottles to the unit.
• Level the device with the feet
in your appliance.
Level the device with the feet
• Level the device with the feet
• Check the door hinge and
• Clean the door seal.
• Check the shelves and
reappears, the problem cannot
any key to deactivate the door.
• If the answer is yes,
-
than necessary.
opening
is
190
adjustable.
adjustable.
adjustable.
reassemble it.
correctly.
replace them
correctly.
Try resetting the
controls by disconnecting
power to the unit.
for 5 minutes and switch it on
again. If the error code
be solved by the user.
service.
Close the door or touch
the alarm. The alarm is
will reset when the door is
closed.
close the door.
Do not open the door wider
-
Clear obstacles and dust
-
Let the appliance run
for a while to reach the set
temperature.
EN
EN
Call for

Publicidad

loading