Malossi Injtronic Manual Del Usuario página 11

Turn the key to the OFF position. The
same procedure must be repeated
with throttle set to the maximum value.
NB: throttle must be at the maximum
level during the entire process.
Turn the key to the ON position: the
indicator light flashes.
Now turn the key to the OFF position,
then turn the key from ON to OFF
three times, stopping in ON. The
"check engine" light should turn on
for three seconds then turn off. Wait
for a few seconds for the light to
flash, indicating that calibration was
successful. Then the light must turn off
definitively.
If the light does not flash, repeat the
procedure from the start. Turn the key
to the OFF position.
11