Publicidad
Idiomas disponibles
Idiomas disponibles
4.1
Mounting the tool
Mounting the prongs (4):
Take the head (2) out of the packaging, insert the combs (1) into the slots of the couplings (7-8) insert the caps (12) and
tighten the screws (13) into the nuts (14) housed in the couplings (7-8); tighten until locked.
4.2
Mounting the tool on the extension pole
Mount the harvester on the pole, engage the drive shaft and tighten the screws (3) on the clamp (Fig. B).
4.3
Control devices
Information on operation and control equipment can be found in the Use and Maintenance Manual of the selected power
unit.
Use and maintenance manual – Translation
of the Original instructions Rev.: 00, Date 06/10/2023
Publicidad
