Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
6.2 When adjusting the temperature, each press of the icon increases or decreases
temperature, or modifies the temperature by 5 ºC degrees. If held down for a long time, the
adjustment will be made continuously.
7.
After setting the cooking time and temperature correctly, touch the power/start/pause
icon; the unit will start to operate.
8.
When the product is operating, the time shown on the display gradually decreases. When
the time is more than 1 minute, the countdown is in minutes and when the time is less than
1 minute, the countdown is in seconds. After completion, the fryer will enter the normal
switch-off state. 3 beeps will be heard, and the fan will stop running after 30 seconds.
9.
When the product is in Air-Fryer operation mode, the heating and fan icons are lit. When
the product is in Steam mode, the fan, water spray and heating icons are lit when the
device is in operation.
10. If there is no operation, the fryer enters standby mode after 1 minute.
11. Steam mode function
11.1 Steam function
1.
The default temperature is 100 °C and the default time is 30 min. The temperature is not
adjustable but the time is.
2.
During this mode, only the steam generator works, the heating element does not work.
11.2 Steam bake function
1.
The default temperature is 180 °C, the default time is 30 min, and the temperature and
time are adjustable.
2.
The heating tube and motor operate at the same time, heating the fryer to the set
temperature. The heating element will operate until the preset temperature is reached.
Once the temperature is reached, the heating element will stop operating and the steam
generator will start generating steam. When the temperature of the basket is below the
minimum temperature range, the steam generator will stop, and the heating element will
start heating again.
11.3 Steamed Vegetables function follows the same process as the Steam function.
11.4 Steamed ribs function
The Steamed Ribs function consists of two cycles. In the first one, the device operates in
1.
Steam mode for 20 minutes at 100 °C.
In the second cycle, the device operates in Airfryer mode for 10 minutes at 200 °C.
2.
Note: this function can also be used to perform cleaning of the device. Temperature and time
are not adjustable.
11.5 Descaling function
1.
Add the proportion of descaler indicated by the descaler manufacturer to the water tank.
2.
Start the descaling function. The left display will show three lights and the cooking time
will be 5 minutes, this is not adjustable.
3.
At this point, the fryer enters the pure steaming function in which the default temperature
is 100 degrees, and the countdown time is 3 minutes. The left display shows three
50
CECOFRY MIST 7000
indicator lights and the right display two. The fan, water spray and heating icons light up.
1.
2 minutes later, the machine enters the air blast function in which the default temperature
is 150 degrees and the countdown interval is 2 minutes. Two indicator lights appear on the
left display and the heating and fan icons are illuminated. At the end of the process, the
display will show END and the fan will continue to run for 30 seconds.
2.
Once this process has been completed, repeat the process a couple of times with clean
water to remove all the descaling product from the device. The interior should be wiped
with a damp cloth to remove all debris from the walls.
CAUTION: when cleaning be sure to take all necessary precautions to avoid contact with steam
as this can be harmful. Do this in a well-ventilated room.
12. Light: control of the fryer's internal lamp ON/OFF
1.
When the unit is in operation or paused, if the light icon is touched, the cavity light will
light up for 30 seconds (if the unit is paused or the basket is removed, the lamp will go
out).
2.
When the light icon is touched again, the cavity light switches off.
13. Air-Fryer function
This function is similar to all air fryer functions. You must select the default programme and
modify the time and temperature of the programme if desired. The programmes have different
temperature and time ranges depending on the function of the programme. No steam is
generated in these modes.
The corresponding temperature and time settings of the default programmes are as follows:
Default
Temperature
Icon
programme
(°C)
Air fry
200
Grill
200
Ferment
40
Preheat
200
Dehydrate
60
ENGLISH
Temperature
Time
Time range
Stirring
range (°C)
18 min
80-200
1-60 min
YES
25 min
80-200
1-60 min
YES
60 min
40-50
12 hrs
-
5 min
80-200
1-60 min
-
3 hrs.
40-60
12 hrs
YES
51
CECOFRY MIST 7000
Publicidad
