cecotec POWER ESPRESSO 20 STEEL PRO Manual De Instrucciones página 51

Please, follow the next 4 steps to descale the machine.
Fill the water tank with coffee machine descaler (4 parts water to 1-part descaler) up to
1.
the MAX mark.
ATTENTION: please also refer to the instructions of the descaler product. Use a commercial
household descaler, or use citric acid instead. In this case, use 100 parts of water to three
parts of citric acid.
2. Place a cup or any other suitable container on the metal tray and press and hold the
double cup button and the steam button at the same time for 5 seconds. The machine
will start the descaling process, which will last 7 minutes and stop automatically.
3. Repeat the above steps until all the water with the descaling product is used up.
4. Then, repeat the process two more times using only CLEAN TAP WATER without descaler.
CAUTION: the parts of the espresso machine and accessories are not dishwasher safe.
5. TROUBLESHOOTING
Problem Cause
Water tank is out of water.
There is no
The water tank is out of place.
water
If there is still no water after
120s of operation or the water
tank is empty, the machine has
been idle for too long.
The steam outlet is blocked.
No water in tank.
No steam
The water tank is out of place.
Solution
Add an adequate amount of water to the
tank.
Replace it again.
Remove the water tank, add 5 ml of
water in the inlet, replace the tank and
use the hot water function once.
Insert a pin into the steam outlet.
Add an adequate amount of water to the
tank.
Replace it again.
POWER ESPRESSO 20 STEEL PRO
ENGLISH
51