Descargar Imprimir esta página

cecotec POWER ESPRESSO 20 STEEL PRO Manual De Instrucciones página 47

Ocultar thumbs Ver también para POWER ESPRESSO 20 STEEL PRO:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Then follow the next steps:
1. Press the steam button. The steam button will start flashing if the temperature is not
high enough to produce steam. Once the preheating process is completed, the steam
button will turn on.
2. Turn the steam regulator knob slightly counterclockwise to remove any condensation on
the steamer, then turn the knob back to turn it off.
3. Place the jug, half-filled with cold milk, under the steamer.
4. Place the steam nozzle just below the surface of the milk. If it is inserted too deep, the
milk will not froth; if it is not inserted deep enough, the milk will start to bubble, and the
froth will disappear. It is important that the steamer is not in the centre, but close to the
edge of the jug, which is slightly inclined.
5. Turn the knob to the ON position. Steam will come out of the steamer.
ATTENTION: the whole process should not take more than 3 minutes, as the machine will
automatically stop dispensing steam after 3 minutes of continuous steaming.
ATTENTION: to froth milk properly, the steam nozzle must always be in contact with the milk
and not with the foam. Therefore, as the foam layer increases, lift the jug slightly, trying to
keep the steamer in contact with the milk, without touching the bottom of the jug.
6. Once the desired foam is obtained, it is necessary to push the steam nozzle deeper in
order to heat the milk thoroughly.
ATTENTION: it is advisable to always keep one hand on the rounded part of the jug so that
you can feel the temperature of the milk rise without frothing.
7. Once the desired result is achieved, turn the steam regulator knob to the "OFF" position to
stop dispensing steam and remove the jug.
ATTENTION: to make the foam more compact, it is advisable to tap the jug on a flat surface
after foaming.
8. Then, press the steam button again to stop the steam outlet. Pour the frothed milk into
the previously brewed espresso.
WARNING: the steamer may be very hot during and after use. To avoid burns, move it only by
resting your fingers on the rubber handle on the steamer.
9. Turn the steam regulator knob to remove any milk residue from the pipe and then turn
the steam knob off again.
10. Do not prepare the coffee immediately after frothing the milk. The temperature of
the heater is too high and the machine is protected against overheating. Under this
protection, the single and double coffee buttons will flash if you press either of them.
Allow the warmer to cool down first; otherwise, the coffee may burn and come out of the
filter holder. Please, follow the next 4 steps to cool down the machine.
POWER ESPRESSO 20 STEEL PRO
ENGLISH
47

Publicidad

loading

Este manual también es adecuado para:

01984