Pari PEP S System Instrucciones De Uso página 55

PROCEDURE:
CAUTION
Risk of infection due to growth of bacteria
Inadequate disinfection encourages the growth of bacteria and thus increases the risk of
infection.
• Observe the mixing proportions indicated and the specified treatment time.
• Ensure that all components are completely submerged in the solution for the whole of
the treatment time. There must not be any air pockets or bubbles.
• Clean all individual parts with a solution prepared according to the manufacturer's instruc-
tions.
In case of visible soiling, use a medium-soft brush (e.g. a toothbrush) which is used ex-
clusively for this purpose.
If the recommended application period is exceeded significantly, the plastic parts may
take on the smell of the medium used.
RINSING:
• Rinse off all parts thoroughly in running water at about 15 °C for 3 minutes.
DRYING:
• Shake the water out of all of the parts.
• Place all parts on a dry, clean and absorbent surface and allow them to dry completely.
23