cecotec MAMBO Serie Manual De Instrucciones página 90

ENGLISH
Speed
Press this icon in standby mode or during the cooking process. The appliance will enter
-
speed-setting mode. The signal on the display will flash. It will then be possible to adjust
the speed. Turn the knob clockwise to choose the desired speed.
The speed range is from level 0 to 10 for Unique XL jar and 0 to 15 for Victory XL jar.
-
If the timer has not been set, the cooking robot will operate with the pre-set times:
-
Heating (without blending): max. 12 hours.
-
Beat at speed 1-7: maximum 1 hour.
-
Beat at speed 8-15: maximum 5 minutes.
-
There is a speed transfer in the structure, so it is normal to hear a faint noise before the
-
motor starts running and in the shift between speeds 7 and 8.
Temperature
Press this icon in standby mode or during the heating process. The appliance enters the
-
temperature setting mode. The signal on the display will flash. It will then be possible to
adjust the temperature. Turn the knob to select the desired temperature.
Temperature range: 37-180 ºC.
-
The device has a LED light that changes colour to indicate whether the jar is above 60
-
°C or not. For this purpose the robot will always show a blue light. If the temperature is
exceeded, it will show a red light.
Heating power
Press this icon in standby mode or during the heating process. The appliance will enter
-
heating power setting mode. The signal on the display will flash. It will then be possible to
adjust the heating power. Turn the knob to select the desired heating power.
The heating power range is from level 1 to 15 for Unique XL jar and 0 to 10 for Victory XL
-
jar.
It will not work if the heating power is selected but the temperature is not. It is
-
recommended to follow the default settings when choosing different temperature levels.
Warning
Please note that the higher the heating power, the greater the amount of heat generated to
reach the preset temperature. This may influence cooking as foods that are dry or low in
water may tend to burn and scorch the base of the jar.
ScreenBlock
Activating the ScreenBlock function (child lock): if you want to lock the display functions,
press the padlock icon at the top left of the main display. A POP UP will then appear asking
if you want to lock the display. If you want to lock, press OK and the display will turn off. To
unlock, touching the display or pressing the knob button will illuminate a "Swipe up to unlock"
icon (similar to how mobile devices work) and you can swipe up on the display to unlock.
90