cecotec CONGA ROCKSTAR 1500 RAY JALISCO Manual De Instrucciones página 25

ENGLISH
Box content
- Conga Rockstar 1500 Ray Jalisco vacuum cleaner
- 2-in-1 accessory
- Accessories for corner
- Jalisco brush
- Suction tube
- Wall bracket
- Power adapter
- Instruction manual
3. PRODUCT ASSEMBLY
Assembling the suction tube and vacuum head
Fig. 2
- To install the vacuum head into the suction tube, match both parts ensuring the tab on the
vacuum head matches the guides on the tube, and insert the tube into the vacuum head
until firmly fixed.
- To disassemble them, press the vacuum-head release button, and pull from the suction
tube while firmly holding the vacuum head.
Note
When assembling these 2 parts, make sure the handle and the brush are facing the same
direction.
Assembling the suction tube, vacuum head, and main body
Fig. 3
To complete the vacuum cleaner's installation, once the vacuum head is mounted on the
suction tube, hold the tube vertically and insert it into the main body.
Battery assembly
Fig. 4
- Insert the battery in the corresponding slot on the main body. Once inserted, it will click
into place. Make sure it's secured in position.
- To remove the battery, press the release button and remove it.
Note
Remove the battery and store it in a safe, dry place if the appliance is not going to be used in a
long period of time.
48
4. OPERATION
You can use this vacuum cleaner in two different manners:
1. Handheld vacuum cleaner, attaching the accessories directly to the main body.
2. Upright vacuum cleaner, using the suction tube with the accessories assembled.
Using the handheld vacuum cleaner
- Press the power button to turn the vacuum cleaner on or off.
- Press the speed knob repeatedly to select the appliance operating speed: Eco and Turbo.
The appliance will turn on in Eco mode by default.
Accessories
This appliance includes different accessories that allow cleaning different types of surfaces,
objects, and dirt. Some of them are suitable for the upright vacuum cleaner, and others are
preferably used with the handheld one.
Jalisco brush
To be used with the upright vacuum cleaner. This brush is especially designed for cleaning hard
floors, but can be used to efficiently clean soft floors too.
2-in-1 accessory
This accessory is preferably used with the handheld vacuum cleaner and allows cleaning
furniture without damaging it.
Accessory for corners
This accessory is preferably used with the handheld vacuum cleaner to reach less accessible
dirt in corners.
Installing the wall bracket
Fig. 5
- Place the wall bracket on the wall and mark the points where the holes are to be drilled
to fix the bracket. It is important that the vacuum head rests on the floor so that the wall
bracket does not support the full weight of the vacuum cleaner.
- Drill the 3 holes (previously marked) and insert the plugs and screws.
- Make sure that the charging base is securely fixed to the wall and place the vacuum cleaner
on the bracket, inserting the charging terminals of the vacuum cleaner into the charging
terminals of the bracket (plastic tab).
- Once the wall bracket is installed, connect the power adapter to the charging port: you
will then be able to charge the vacuum cleaner by simply sliding it up and down the wall
bracket.
ENGLISH
CONGA ROCKSTAR 1500 RAY JALISCO 49