Krampouz Samba Instrucciones De Uso página 19

CONNECTION
Check that the temperature control knobs are set to "Off".
Ensure that the connection complies with the regulations in the country of use.
The plancha must be connected via a hose and connector, located at the back of the
appliance (see Figure 3). To connect it, remove the yellow protective cap on the ½" gas
connector and keep it for storing.
For example, for France: NF hose for 3rd family gases butane/propane:
- NF D36-125 metallic hose with unlimited lifespan.
- NF D36-112 hose with a lifespan of 10 years
The hose should be a suitable length, up to 1.5 m, and must be visible over its entire
length.
Check that the hose is in good condition and replace it if it appears cracked or damaged.
The hose must lie naturally with no twists or pulling. Ensure it does not come into contact
with any hot parts of the appliance. After connecting the hose to the appliance, connect
the pressure regulator to the hose and gas cylinder as per the instructions supplied with
the pressure regulator and hose. Then, perform a leak-tightness test as follows:
- Check leak-tightness by using soapy water away from any heat source (cigarettes,
electrical appliances, etc.).
- Never test leak-tightness using a flame.
- Put soapy water on all connections, open the gas inlet and then check for the
formation of bubbles.
- If any bubbles form, then there is a leak. Close the gas cylinder and tighten the
connections, then perform another leak-tightness test.
- If the leak persists or comes from a different part, stop using your plancha and
contact your dealer.
Never use an appliance that leaks gas.
CHANGING THE GAS CYLINDER
Always turn off the control knobs and gas cylinder valve before changing the gas cylinder.
Change the gas cylinder in a well-ventilated location away from any heat source
(cigarettes, electrical appliance, etc.).
Whenever you change the gas cylinder, perform a leak-tightness test.
-
- 19