Publicidad
Idiomas disponibles
Idiomas disponibles
When Antifreeze mode is active, press the key (A2) to set switching on of the
appliance; press the keys (A5) or (A6) to increase or decrease time according
to this sequence:
(0h (Timer off) --> 1h --> 2h --> .. 23h --> 24h --> .. 0h (Timer off) --> ..).
When the function is active, the LED (L7) lights up.
3.4.c - Mode key (A3)
Press the key (A3) on the panel or through the remote control to select the function;
the LED in correspondence of the desired mode lights up.
Antifreeze mode
The appliance heats only when the detected temperature is below 5 degrees. The
appliance stops working if it detects a room temperature above 7 degrees.
When this mode is active, it is not possible to set the desired temperature.
Eco mode
The appliance heats with a power equal to 1000W (low power).
When this mode is active, it is possible to set temperature by pressing the key (A4)
and selecting the desired value using the keys (A5) and (A6).
Heating mode
The appliance heats with a power equal to 2000W (high power).
When this mode is active, it is possible to set temperature by pressing the key (A4)
and selecting the desired value using the keys (A5) and (A6).
When the desired temperature is set, the value flashes for approximately 10 sec-
onds and, once set, the display returns to show the detected room temperature.
3.4.d - Command lock (L5)
After 1 minute of inactivity, the appliance enters stand-by mode and the LED (L5)
lights up on the display.
Press the keys (A5) or (A6) to remove the commands lock. The Led (L5) switches off.
3.4.e - WIFI key
When the appliance switches on, it enters device search mode and the LED
(L6) flashes.
If it is desired to activate the function in a second moment, keep the key (A1)
pressed for a few seconds on the panel until the LED (L6) starts flashing.
EN - 14
Publicidad
