Thermador Professional PRO HARMONY PRD30 Manual De Instalación página 23

High Shelf
Figure 20: High Shelf & Low Back Front View
When installing against a combustible surface, a High
Shelf or Low Backguard is required. A THERMADOR ®
High Shelf or Low Backguard must be purchased
separately. See clearances on page 6 for more
information.
When using the Flush Island Trim, THERMADOR
recommends a minimum 12" (305 mm) rear clearance to a
combustible surface (see Figure 1, Cabinet Clearances).
Clearances from non-combustible materials are not part of
the ANSI Z21.1 scope and are not certified by
CSA. Clearances of less than 12" (305 mm) must be
approved by the local codes and/or by the local authority
having jurisdiction.
High Shelf Assembly
1. Remove protective plastic.
2. Slide the shelf onto the backguard channel.
3. Install the included stainless screws along the topside
of shelf and into the back of the shelf.
4. Begin with Backguard Installation.
t'-
(_
Q_
t-
t--
"-3
o
5
High Shelf 'a
Low Back°
Figure 22: Backguard Installation
Backguard Installation
1. Remove protective plastic.
2. Depending on model, remove the (3) or (4) T-20 Torx
stainless screws in the front face of the included Flush
Island Trim, the (4) drill point screws securing the trim
to the side panels, and the (2) or (4) drill point screws
securing the piece to the back panel. Lift up to fully
re move.
3. Align the back panel of the new accessory with the
flanges on the range side panels right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws in the new backguard's front and
back panels.
Re-install (4) drill point screws to secure the backguard's
back panel to the side panels on the back of the range.
Figure 21 : High Shelf Assembly Rear View
English 21