Husqvarna K1 PACE Manual Del Usuario página 13

Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with safety devices that are
damaged or do not operate correctly.
• Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your HUSQVARNA approved
service agent.
• Do not change the safety devices.
• Do not use the product if protective plates, protective
covers, safety switches or other protective devices
are damaged or not attached.
Functions of the control panel
6
5
4
3
2
1
1. On/Off button.
2. Battery status indicator.
3. Rail fixture indicator, engaged or disengaged. Only
for K1 PACE Rail. Refer to
product on page 35 .
®
4. Bluetooth . Refer to
on page 23 .
5. Temperature warning indicator, high or low. Refer to
Troubleshooting of the product on page 35 .
6. X-Halt warning. Refer to
product on page 35 and X-Halt on page 13 .
7. Error/Warning indicator. Refer to
the product on page 35 .
8. Accessories On/Off button (not used).
To do a check of the control panel
1. Push and hold the On/Off button until the battery
status indicator comes on. Refer to
product on page 26 .
1598 - 007 - 28.09.2023
Read the warning
7
8
Troubleshooting of the
®
Bluetooth wireless technology
Troubleshooting of the
Troubleshooting of
To start the
2. Push and hold the On/Off button until the control
panel goes off.
Power trigger lockout
The power trigger lockout prevents accidental operation
of the power trigger. If you put your hand around
the handle and press the power trigger lockout (A), it
releases the power trigger (B). If you release the handle,
the power trigger and the power trigger lockout move
back to their initial positions.
A
Automatic stop function
The automatic stop function stops the product and
makes the control panel go off if you do not use it for
3 minutes.
X-Halt
The X-Halt function is an electronic brake system that is
engaged if a kickback occurs. The function can not fully
prevent personal injury from a kickback, but it decreases
the risk. A safe working technique is necessary to
prevent kickbacks and to decrease the risk of injuries.
The X-Halt function is always on when the product is on.
If the function is engaged, the control panel shows the
X-Halt waning symbol until the product becomes cool.
Functions of the control panel on page 13 . For
Refer to
more information, refer to
on page 35 .
B
Troubleshooting of the product
13