Husqvarna K1 PACE Manual Del Usuario página 31

3. Move the product rearward and forward to decrease
the contact surface between the cutting blade and
the rail. More contact surface increases the risk of
glazing the cutting blade or making it blunt.
4. Cut the rail.
A
B
C
a) Cut through the section at the top (A).
b) Cut through the section in the middle (B).
c) Cut through the section in the bottom (C).
5. If the cut cannot be completed from 1 side, the
product must be turned around.
a) Stop the product. Refer to
page 27 .
b) Remove the product from the rail fixture.
c) Install the product with its left side to the rail
fixture.
d) Put the cutting blade against the rail and make
sure that it is in the center of the cut.
1598 - 007 - 28.09.2023
To stop the product on
e) Adjust the position of the cutting blade, if it is
necessery. Loosen the 2 crews (A) and adjust
(B) the position of the cutting blade.
A
f) Tighten the 2 screws (A)
g) Continue to cut.
6. Complete the cut.
7. Stop the product.
8. Remove the product from the rail fixture.
9. Remove the rail fixture from the rail.
To cut rail, recommendations
Note:
With correct cutting technique, the time to cut
a 50 kg/m rail is 1-2 minutes and to cut 60 kg/m rail is
1.5-2.5 minutes. If more time is necessary, do a check
of the cutting technique and the cutting blades. Incorrect
cutting technique causes problems, such as cuts that
are not accurate. An incorrect, blunt or worn cutting
blade can also cause cuts that are not accurate.
• To get accurate cuts, only use high quality cutting
blades that are made specially to cut rail.
• To make straight cuts, start with these steps:
1. Make sure that the rail fixture is correctly
installed.
2. Apply full throttle until the blade is at full
speed.
3. Start to cut.
4. Move the product forward and rearward over
the rail.
5. Apply full throttle and keep full speed until
the cut is completed.
• Hold the product handle with your hands aligned
with the cutting blade. This gives a straight cut and
decreases the wear on the cutting blade.
B
31