Stiga ST 3255 P Manual De Instrucciones página 43

EN
3.5 CHECKING THE CLUTCH LEVERS
The control wires might need adjusting before using the
snow thrower for the first time.
See "7.4" below.
3.6 TYRE PRESSURE
Check the air pressure in the tyres. See "6.5".
4 CONTROLS
The motor is equipped with a protection grid. The
motor may never be started without the grid fitted
or with a defect grid.
See fig. 1.
4.1 THROTTLE (K)
Controls the engine's revs. The throttle has two positions:
1. Full throttle
2. Idling.
4.2 CHOKE (L)
Used when starting a cold engine. The choke has two
positions:
To the left the choke is closed (for cold starting).
To the right the choke is open.
4.3 PRIMER (J)
Pressing the rubber prime-starter squirts fuel into
the carburettor intake pipe to make it easier to start
a cold engine.
4.4 FUEL COCK(M)
The fuel cock opens the fuel supply to the carburettor.
The fuel cock shall always be closed when the
machine is not in use.
To the left - open.
Up - closed.
4.5 STOP SWITCH (S)
Used to stop the engine. The switch has two positions:
Pulled out-OFF – The engine stops, engine can not
start.
Pushed in-ON – The engine can be started, engine
running.
4.6 STARTING HANDLE (U)
Manual cord start with rewinding.
4.7 OIL FILLER CAP/OIL DIPSTICK (P)
For filling and checking the oil level in the engine.
4.8 FILLER CAP (C)
For filling with petrol.
42
ENGLISH
4.9 OIL DRAINING PLUG (Q)
For draining the old engine oil when changing the oil.
4.10 SPARK PLUG PROTECTION (F)
The protection is easily removable by hand. The spark plug
is located under the protection.
4.11 GEAR LEVER (D)
The machine has 4 forward gears and 2 reverse to regulate
the speed.
The gear stick must not be moved if the driving
clutch lever is activated.
4.12 CLUTCH LEVER- DRIVING (N)
Engages the wheels when put into gear and the lever
is pushed towards the handle.
4.13 CLUTCH LEVER- AUGER (O)
Connects the auger and fan when the lever is pushed
towards the handle.
4.14 ADJUSTMENT LEVER (E)
Changes the direction of the discharged snow.
4.15 SHOES (H)
Used to set the height of the auger housing above the ground.
4.16 SCRAPING BLADE (V)
Used to leave an even surface after the snow thrower and
absorb the wear from the ground.
4.17 CHUTE DEFLECTOR (A)
Losen the levers and adjust the chute deflector to a suitable
height.
Low - shorter ejection distance.
High - longer ejection distance.
4.18 CHUTE CLEARING TOOL (G)
The chute clearing tool is located in a holder on top of the
auger housing. The chute clearing tool must always be used
when cleaning the discharge chute and augur.
Always stop the engine before clearing the chute.
Never clear the snow discharge chute with your
hand. Risk of serious injury.
Original instructions for use