Sagola 3300 GTO Manual De Instrucciones página 33

Fig.04
Open the product regulator until the appropriate amount of product comes out. Now you have the
maximum spraying width (spraying pattern). You can reduce this according to your needs by closing the
spray width regulator. (see Fig.05 and 06)
Please be sure that you put the spray gun properly by keeping its perpendicularity to the piece
to be painted in order to achieve the maximum transfer of the sprayed product and obtain the
best finishing quality
11.1.- Clean Air
The air used for spraying must reach the gun free of impurities, aerosols, oil, silicone and solid
particles. To do this you must eliminate these with coalescent filter units.
The use of air treatment equipment with built-in pressure regulators is recommended
(SAGOLA 5200X, 5300X or 5300X Plus models).
11.2. Sufficient volume of air
A sufficient volume of air can be supplied to the gun by means of an air compressor of adequate
power (1HP equals 110 L/min approximately), a good compressed air network and by avoiding pressure
drops through the use of antistatic, silicon-free air hoses with a minimum inside diameter of 8 mm.
and resistant to the spraying air pressure (minimum 20 bar) and to the aggressive effects of paint
solvents. Before assembling the air network, you must check on the air tightness of the hose.
Use antistatic air hoses. Should an antistatic air hose not be
available, you must attach the unit to a ground connection in order
to eliminate any static electricity.
The total derivative resistance must be <1 million Ohms.
www.sagola.com
an Elcometer company
Fig.05 Fig.06
EN 33