Sagola 3300 GTO Manual De Instrucciones página 36

an Elcometer company
Fig.09 Fig.10
12.2. Cleaning or replacement of the product filter
- Gravity / suction version:
If there is any cleaning liquid or product remaining in the tank, return it to its corresponding containers.
To avoid any spillage, keep the pistol in a vertical position and clean as thoroughly as possible.
Holding the pistol firmly by the handle, disassemble the tank by
unscrewing it from the body of the pistol.
Extract the product filter and if there is any cleaning liquid or product
remaining in the body of the pistol, return it to its corresponding container.
Clean or replace the product filter as needed, taking into account that
the impurities will cause defects in the finish and/or obstructions.
Assemble the product filter again, inserting it all the way into the hole in the input connector.
Fit the tank by screwing it firmly onto the body of the pistol, to avoid product leaks.
Tighten the filler cap firmly.
In the version with the non-drip cap, tip it forward (paint up) or back (paint down) as necessary.
Check there are no leaks.
www.sagola.com
EN 36