Progress Lighting P250108 Manual De Instalación página 12

CAUTION: Before starting installation, disconnect
the power by turning off the circuit breaker or
removing the fuse at fuse box. Turning power off
using the fan switch is not sufficient to prevent
electric shock.
Step 1. Remove 3 screws from the posts of the
decorative housing and keep it for future use. (Fig.
15)
Step 2. While holding the LED light kit under your
fan, make the polarized plug connections: (Fig. 15)
- White to white
- Black to black
Step 3. Align the holes from the LED light kit to
the holes from the decorative housing, and secure
the LED light kit with screws previously removed.
(Fig. 15)
Step 4. Position the notches in the outer rim of the
LED light kit so they line up with the tabs on the
inside of the rim on the light kit mounting plate.
Carefully lift the LED light kit up inside the glass
shade and secure it to the fan by turning the LED
light kit clockwise until snug. (Fig. 16)
9. Installing the Light Kit and Glass Shade
NOTE: The metal light cover included with your
fan is an option to replace the light kit in the event
that you prefer not to use the light feature of your
fan. The metal light cover is not necessary for the
light operation; it can be saved for later use if
desired.
Figure 15
Decorative
housing
Wire
connectors
Figure 16
LED light kit
Screws
LED light kit
Notches
Tabs
Glass shade
assembly
Metal
light cover