Progress Lighting P250108 Manual De Instalación página 8

REMEMBER to turn off the power. Follow
the steps below to hang your fan properly:
Step 1. Remove the decorative canopy bottom
cover from the canopy by turning the cover
counter clockwise.(Fig. 7)
Step 2. Remove the mounting bracket from
the canopy by removing 1 of 2 screws from
the bottom of the mounting bracket and
loosening the other one a half turn from the
screw head. Next, turn the canopy counter
clockwise to remove the mounting bracket
from the canopy. (Fig. 7)
Step 3. Pass the 120-volt supply wires
through the center hole in the ceiling hanger
bracket as shown in Fig. 8.
Step 4. Secure the hanger bracket to the
ceiling outlet box with the screws and
washers provided with your outlet box.
Step 5. Remove the hanger pin, lock pin and
set screws from the top of the motor
assembly. (Fig. 9)
Step 6. Route the wires exiting from the top
of the fan motor through the collar cover,
canopy cover, canopy and then through the
ball / downrod. (Fig. 9)
5.
Step 7. Align the holes at the bottom of the downrod
with the holes in the collar on top of the motor
housing (Fig. 9). Carefully insert the hanger pin
through the holes in the collar and downrod. Be
careful not to jam the pin against the wiring inside
the downrod. Insert the locking pin through the hole
near the end of the hanger pin until it snaps into its
locked position, as noted in the circle inset of Fig. 7.
WARNING
FAILURE TO PROPERLY INSTALL
LOCKING PIN AS NOTED IN STEP 7
COULD RESULT IN FAN LOOSENING AND
POSSIBLY FALLING.
Step 8. Tighten two set screws on top of the fan
motor firmly. (Fig. 9)
Step 9. Place the downrod ball into the hanger
bracket socket. (Fig. 10)
Figure 7
Ceiling
hanger
bracket
Figure 8
Canopy Canopy
Canopy cover Canopy cover
Pin in locked
position
Ceiling hanger
bracket
Ceiling
canopy
Hanger pin Hanger pin
Canopy
Figure 9
cover
CUL Listed
electrical
box
Washers
Mounting screws
120V Wires
(supplied with
electrical box)
Supply wires
Ball/downrod
assembly
Collar cover
Collar cover
Lock pin Lock pin
Set screws Set screws