Publicidad
Idiomas disponibles
Idiomas disponibles
Attaching the Decorative
Housing
Step 1. Begin by using the original product
packaging to create a base to hold the fan. Place
the fan motor with the bottom facing up.
Step 2. Remove 1 of the 3 screws from the
mounting ring and loosen the other 2 screws. (Do
not remove)
Step 3. Place the key holes on the decorative
housing over the 2 screws previously loosened
from the mounting ring, turn decorative housing
until it locks in place at the narrow section of the
key holes. Secure by tightening the 2 screws
previously loosened and the one previously
removed. (Fig. 5)
Screw
Mounting ring
Figura 5
Attaching the Fan Blades
WARNING: To reduce the risk of personal
injury, do not bend the blades while installing,
balancing the blades, or cleaning the fan.
Step 1. Fasten blade to motor with provided
blade support plates and screws. Make sure
screws are TIGHT! Loose motor screws can
contribute to unnecessary hum or wobble during
operation. (Fig. 6)
Step 2. Repeat these steps for the remaining
blades.
Decorative
housing
Screws
Fan motor
assembly
Screws
Blade support
plates
Blades
Figure 6
4.
Publicidad
