H.ordering Parts; Maintenance Chart; Tools You Will Need - Quickie Freestyle M11 Manual De Instrucciones

38
H. ORDERING PARTS
When you order parts, provide the following:
1. Model of chair
2. Serial number of chair
3. Left hand or right hand control
4. Part number, description and quantity of parts you need.
5. State reason for replacement.
I. MAINTENANCE CHART
You should check the items on this chart at the indicated intervals. If any of the items are
loose, worn, bent or distorted, immediately have them checked and/or repaired by your
authorized Sunrise supplier. Frequent maintenance and servicing will improve performance
and extend wheelchair life, and help prevent injuries.
CHECK...
Charge batteries
Check tires for proper inflation level
Check batteries for proper electrolyte level (wet cell only)
Check plugs and connectors for proper connections
Check all moving parts for wear
Inspect all nuts, bolts and fasteners for looseness or wear
Inspect upholstery for wear & tighten seat sling as needed
Remove and inspect motor brushes
Service by authorized supplier
J. TOOLS YOU WILL NEED
1. Basic Tool Kit:
To set-up, adjust and maintain your chair you will need the following tools:
• 3mm Allen Wrench
• 5mm Allen Wrench
• 6mm Allen Wrench
• 8mm Allen Wrench
• 13mm Open-end Wrench
• Phillips screwdriver #2
• 17mm Socket Wrench
You can obtain a multi-purpose tool kit from Sunrise, or buy the tools you need from a hardware store.
2. Torque Wrench:
If you plan to adjust and maintain this chair yourself, Sunrise recommends that you use a
torque wrench.
NOTE– The wrench must measure inch-pounds. You can buy a torque wrench and proper sockets from a
hardware store.
930583 Rev. F
E n g l i s h
• 13mm Socket Wrench
• 16mm Open-end Wrench
• 19mm Open-end Wrench
• Flat Head Screwdriver
• Standard Tools
• Tire Pressure Gauge









X I I I . M a i n t e n a n c e