Vetus E-DRIVE MPE1MBV Manual De Instalación página 10

ENGLISH
3.5 Meaning of LED warning symbols
Startup sequence
Propulsion active (propeller moving) - Normal mode
Power mode active. Propeller not moving
Propulsion active (propeller moving) - Power mode
CAN warning - Blockage (overload)
CAN alarm - High voltage (alternating red/green)
Overheating warning (motor is limited but functional)
Overheat alarm
High motor current (voltage battery indication impossible)
3.6 Meaning of LED battery charge indicator symbols
24 V system @ 0 - 10 A
> 25.4 V
24.6 - 25.4 V
23.6 - 24.6 V
22.4 - 23.6 V
21.6 - 22.4 V
24 V system @ >10 A
> 25.4 V
24.2 - 25.4 V
23.0 - 24.2 V
22.2 - 23.0 V
21.6 - 22.2 V
The level shown on the battery charge indicator is based on the volt-
age measured.
- If more power is being used, the cruising range will decrease, and
the level shown on the battery charge indicator will be lower.
- If less power is being used (you're sailing slower), it will be possible
for the voltage to increase again. The same applies for the level
shown on the LED battery charge indicator.
10
370602.11
When switched on, all LED symbols light up momentarily
x
x
x
x x
x
24 V system @ 0 - 10 A
> 50.8 V
49.2 - 50.8 V
47.2 - 49.2 V
44.8 - 47.2 V
43.2 - 44.8 V
24 V system @ >10 A
> 50.8 V
48.4 - 50.8 V
46.0 - 48.4 V
44.4 - 46.0 V
43.2 - 44.4 V
The level shown on the battery charge indicator on the
MPE1MBV panel is an approximate level only. Use a battery
monitoring system (CANNS500) to get a more accurate read-
ing.
x
(x)
(x) x
(x)
(x) = flashes, x = continuously on
LED battery charge indicator
LED battery charge indicator
n
ote
Installation manual MPE1MBV E-DRIVE Monitoring Panel
(x)
x