cecotec BONGO X45 CONNECTED Manual De Instrucciones página 33

ENGLISH
3. Light
4. Warning
5. Bluetooth
6. Speed indicator
7. Trip or ODO
8. Distance
9. Units of distance
10. Battery level
11. Speed units
12. Cruise control
13. Brake lever with bell
14. Display
15. Power button
16. Accelerator
Note:
The graphics in this manual are schematic representations and may not exactly match the
product.
3. BEFORE USE
- This electric scooter features packaging designed to protect it during transport. Take the
electric scooter out of its box and remove all packaging materials. You can keep the original
box and other packaging elements in a safe place. This will help you prevent product
damage when transporting it in the future. In case the original packaging is disposed of,
make sure all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or not in good condition, immediately contact the official Cecotec Technical
Support Service.
Box contents
Fig. 24
1. Bongo X45 Connected Series electric scooter
2. Allen key
3. Charger
4. Screws x4
64 ORIGINAL MANUAL TRANSLATION
4. OPERATION
Assembly and configuration
Fig. 25
1. Fold out the handlebar, lock it and lower the kickstand.
2. Install the handlebar on the stem.
3. Tighten the screws on both sides of the stem with the T-shaped Allen key.
4. After assembly, press the power button to check for proper operation.
Charging the scooter
Fig. 26
The electric scooter is fully charged when the LED light on the charger changes from red
(charging) to green (continuous charging).
1. Open the rubber charging port cover
2. Connect the charger to the charging port.
3. When charging is complete, re-attach the rubber cover.
How to ride
Warning: use helmet, elbow and knee pads. Please read the instructions carefully before using
the product. Do not modify the braking system. Check the instructions for further information.
1. Switch on the scooter and check the power indicator.
2. Place one foot on the deck and push off the ground with the other foot. When the
scooter starts to coast, place both feet on the platform and press the accelerator. Note:
Acceleration will start when the coasting speed exceeds 5 km/h.
3. The accelerator automatically switches off when the scooter is at a complete standstill. To
restart the scooter, repeat step 2.
4. Release the accelerator and the Kinetic Energy Recovery System (KERS) will automatically
start to brake slowly; press the brake lever to brake suddenly.
5. Tilt your body in the direction of steering when turning and slowly turn the handlebar
Control panel
-On: one short press.
-Power Off: a long press for 2 seconds.
-Light: two short presses.
-Drive mode: one short press.
1. PEDESTRIAN mode: In this mode, the scooter can reach 6 km/h.
2. COMFORT mode: In this mode, the scooter can reach 15 km/h.
3. SPORT mode: In this mode, the scooter can reach 25 km/h.
-Cruise control: three short presses.
-Units: five short presses.
-Gyroscope: hold down the brake lever and seven short presses.
ENGLISH
BONGO X45 CONNECTED 65