Publicidad
Idiomas disponibles
Idiomas disponibles
User manual and warranty card
operation manual applies to various models of mowers. The mower described may differ from your
purchase. Read the passages that refer to the device model you have.
CONSTRUCTION OF PETROL MOWER
Illustrative drawings can be found on page 3, Fig. 1-2
1 Handle
2 Engine brake lever
3 Drive lever with line
4 Clamp lever
5 Starter handle with cable
6 Starter cable attachment point
7 Basket
8 Rear wheel
9 Handle connection nut with housing
10 Water cleaning system connection
11 Front wheel
12 Air filter cover
13 Engine
14 Fuel-filler cap
15 Oil filler cap
16 Muffler
17 Spark plug pipe
18 Side discharge cover
19 Side discharge chute
20 Basket full indicator
21 Cable adjustment
22 Grass ejection cover
23 Cutting height adjustment lever
ASSEMBLY
The mower handle is factory set in the storage position.
Set the lower handle to the use position, making sure that the handle is between the stops and
tighten it with the wing nut (Fig. 3).
Set the upper handle to the use position and lock it with the clamping lever. Turning the nut
changes the length of the clamping lever bolt, thus increasing or reducing the clamping force.
Fastening occurs when the clamp is pressed against the handle in the direction of the arrow on
Fig. 4.
Attention! Too short the bolt with a nut may cause the clamping lever not to be tightened,
and consequently damage the lever.
Attention! When unfolding and folding the handle, make sure that the engine brake cable
does not break or bend. A bent or otherwise damaged cord may prevent the mower from
working properly.
19
English
Publicidad
