Publicidad
Idiomas disponibles
Idiomas disponibles
In the event that the wiring and the signal wire assignment on the vehicle do not
unequivocally coincide, comparison with the current flow diagram may be necessary.
"Signal assignment comes before signal colour". We reserve the right to correct typing errors
Route all wiring harnesses of the installation kit along existing vehicle wiring harnesses, secure with
the supplied cable ties and / or insert in the existing cable runs.
Refit all trim parts and any parts removed.
Reconnect the earth wires to the batteries.
3. Coding
The additional warning lamp (C2) for checking the operation of the trailer indicators is not
fitted to the vehicle. In addition, the trailer lights (with the exception of the fog light and
reversing light) are monitored using the light failure monitoring element in the multi-function
•
Crafter: The encoding is carried out via the Servicenet, or contact the NSC
(Commercial Vehicle Service Centre)
TGE: Vehicle parameterisation: The corresponding part number for the vehicle
parameterisation of the trailer operation can be found in the selection and order
catalogs for MAN original software in the electronic MAN spare parts catalog
MANTIS.
•
Modifications to the encoding are only adopted after changing the ignition
•
Then, as in the beginning, perform a system query via the diagnosis function and
delete any possible error codes
1. It must be ensured that the latest version of
for the vehicle test.
2. The request for the vehicle configuration only occurs once if the procedure and test
operation are carried out without any errors.
3.
Unprompted multiple call-ups generate error messages and have no effect on the
configuration.
4. Function test
Check all functions using a suitable test device.
06.04.2020-071973
However, the following generally applies:
or make alterations.
NOTE:
display.
WARNING NOTES:
ODIS service
is used on the workshop tester
12 / 85
Publicidad
