Frequently Asked Questions - Oster XPERT Serie Manual De Instrucciones

LIQUIDS
Put liquids into the jar first, unless the recipe says otherwise. Add more liquid if
ingredients are not blending properly.
USING THE FILLER CAP
Do not remove the lid while in use. Instead, open the filler cap to add smaller
ingredients.
ICE CRUSHING
Without Liquid: use pulse button until you achieve desired results.
With Liquid: Add desired amount of ice cubes and water until ice floats. Blend on High
"3" until you achieve desired results then strain off water.
WORKING WITH HOT FOODS OR LIQUIDS
WARNING: When you work with HOT FOODS, remove the filler cap to vent
steam. Tilt the lid away from you partially covering the opening. Keep hands and
other exposed skin away from the lid opening to prevent possible burns.
When you work with HOT LIQUIDS, remove the filler cap and start at a low
speed, and then gradually increase to a faster speed. Do not add liquid over
the 1-Liter (4-cup) level. Always keep hands away from steam.
INGREDIENT QUANTITIES
Use only the amount of food suggested in the recipes. If you want greater
amounts, prepare in batches. Using larger amounts may overload and strain
the motor. You might also get different results from those described.
FRE QU EN T LY A SK ED QUESTIO NS
WHY DOESN'T THE BLENDER TURN ON?
• Make sure the base is plugged in an active power receptacle.
• Verify blinking red light is active after pushing power button
• Make sure the control knob is pressed "OPRIMIR" to start "INICIAR".
• Refer to ADVANCED MOTOR PROTECTION SYSTEM (A.M.P.) section on
the next page.
HOW CAN I PREVENT LIQUIDS FROM LEAKING OUT?
Check to see that the sealing ring is correctly assembled in between the blade
and the jar.
BL E N DI NG T IPS
En g lish-8
.