Publicidad
Idiomas disponibles
Idiomas disponibles
3. Install the guide bar on the bar bolt.
4. Steer the guide bar to its most rear position. Lift the
saw chain above the drive sprocket and engage it in
the groove on the guide bar. Start on the top edge of
the guide bar.
5. Make sure that the edges of the cutters point forward
on the top edge of the guide bar.
6. Install the drive sprocket cover and steer the chain
adjuster pin to the hole in the guide bar.
7. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
8. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
9. Tighten the bar nut with your fingers.
10. Tighten the saw chain. Refer to
of the saw chain on page 23 for instructions.
To install the air intake cover (optional)
If you cut materials that cause much dust and small
particles in the air, a air intake cover is recommended
for use.
Introduction
WARNING:
safety chapter before you use the product.
12
To adjust the tension
Operation
Read and understand the
1. Hold the air intake cover against the fan housing.
Make sure to put the hole in the air intake cover on
the right side of the hole in the fan housing.
2. Carefully push the air intake cover against the fan
housing until you hear a click.
3. Push the air intake cover to the left until the holes
align.
4. Install the screw.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product.
•
Extended product information.
CLICK!
2120 - 006 - 09.10.2023
Publicidad
