Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance
Do a check of the saw chain. Look for cracks and make sure that the saw chain
is not rigid or unusually worn. Replace if necessary.
Sharpen the saw chain. Do a check of its tension and condition. Do a check for
wear on the drive sprocket and replace is necessary.
Clean the air inlet on the product.
Make sure that the screws and nuts are tight.
Make sure that the keypad works correctly and that it is not damaged.
Use a file to remove burrs from the edges of the guide bar.
Lubricate the needle bearing. Refer to
24 .
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
Empty and clean the oil tank.
Blow through the product and battery cooling slots gently with compressed air.
Do a check of the clutch centre, clutch drum and clutch spring.
Maintenance and checks of the safety
devices on the product
To do a check of the front hand guard
Regularly do a check of the front hand guard.
1. Make sure that the front hand guard does not have
damages such as cracks.
2. Make sure that the front hand guard moves freely
and that it is attached safely to the product.
2120 - 006 - 09.10.2023
To lubricate the needle bearing on page
To do a check of the brake trigger
1. Start the product and make sure that the saw chain
2. Hold the product tight. Put your hands around the
3. Apply full power and tilt your left wrist forward to
4. Make sure that the saw chain stops directly.
Before
use
X
X
X
X
X
does not touch the ground or an object. See
the product on page 14 for instructions.
handles.
engage the chain brake.
Weekly
Monthly
X
X
X
X
X
X
To start
19
Publicidad
