Descargar Imprimir esta página

Greencut GD750X Manual De Instrucciones página 68

Ocultar thumbs Ver también para GD750X:

Publicidad

Idiomas disponibles

Idiomas disponibles

68
TROUBLESHOOTING
Good maintenance will extend the useful life of the machine. Prolonged or regular use may require more intensive
maintenance so that the machine continues to function properly. The table includes some of the most common
problems, their causes and solutions. If the machine does not start:
THE
THE SPARK
COMPRESSION
OF THE CYLINDER
PLUG IS OK
IS NORMAL
Yes
Yes
Yes
No
Lack of
Yes
compression
The engine
doesn´t turn
If the engine does not work properly, please find below some of the possible problems, possible causes and solutions:
PROBLEM
The machine chimes
Engine overheating
Engine does not work
properly
Engine stops or does
not idle
NOTE: In the event of not being able to resolve the problem, get in touch with an Authorised
Service Centre.
POSSIBLE CAUSE
• There is no fuel in the tank.
• The fuel filter is dirty.
• There is water in the fuel.
• The fuel you are using is not correct,
• The carburettor is dirty.
• The switch is on the off position.
• Spark plug dirty.
• Spark plug pipe is not properly connected.
• Loose spark plug.
• Worn pistons.
• Scratched cylinder.
• Choked engine.
POSSIBLE CAUSE
• Worn segments.
• Piston seizure.
• Loose crankshaft.
• Loose clutch.
• Operator is overworking the
unit.
• Clogged/dirty exhaust.
• Improper fuel.
• Carburador sucio.
• Filtro de aire sucio.
• Filtro de combustible sucio.
• Carburador mal regulado.
• Refuel.
• Clean the filter.
• Replace it.
• Change the fuel for one with the
correct octane.
• Take your machine to an authorised
service centre.
• Switch to the "I" position.
• Clean the spark plug.
• Connect it.
• Tighten.
• Take your machine to an authorised
service centre.
• Take your machine to an authorised
service centre.
SOLUTION
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Pause every 10 minutes or allow the engine to
cool down.
• Take your machine to an authorised service centre.
• Replace fuel as appropriate.
• Take your machine to an authorised service centre.
• Clean the filter.
• Clean the filter.
• Take your machine to an authorised service centre.
SOLUTION

Publicidad

loading