Publicidad
Idiomas disponibles
Idiomas disponibles
FUEL SAFETY
•
Gasoline and oil are dangerous. Do not inhale or ingest. If you swallow fuel and/or oil, seek medical advice
promptly. If it comes into contact with fuel or oil, clean with plenty of soap and water as soon as possible. If
irritated eyes or skin occur afterward, consult a doctor immediately.
•
Fuel and oil are dangerous and highly flammable chemicals. If they become inflamed, extinguish the fire with a
dry powder extinguisher.
•
Do not spill fuel or smoke near the machine.
•
Always turn off the engine before refuelling.
•
Always refuel in well-ventilated areas. And never with the engine running, or hot.
•
If a fuel leak is found, do not start or run the engine until the leak has been repaired.
•
Make sure the fuel cap is properly closed.
•
Fuel stored in the carburetor for long periods of time can cause a hard start and may also lead to further repairs
and maintenance.
•
Always store fuel in approved containers.
MAINTENANCE, TRANSPORTATION AND STORAGE SAFETY
•
Use this machine, accessories, tools, etc. in accordance with these instructions and in the manner provided,
taking into account the working conditions and the work to be performed.
•
After the engine has stopped, the muffler will be warm.
•
Reduce the engine speed when turning off the engine, if the engine is equipped with a fuel shut-off valve, turn
off the fuel when the engine has stopped.
•
Before adjusting or repairing the machine, stop the engine and remove the spark plug wire. These precautions
reduce the risk of accidentally starting the machine. Never attempt to make motor adjustments while the unit
is running.
•
Always clean the machine of dust and dirt after finishing work, do not use grease solvents. Always keep the
machine clean, especially the fuel tank, its surroundings and the air filter.
•
Carry out regular maintenance on the machine. Do not attempt any maintenance or repair work not described in
the instruction manual. We recommend that maintenance and repairs not described in this manual be performed
only by the Official Technical Service.
•
Always make motor adjustments with the unit supported on a flat, clear surface.
•
Check that moving parts are not misaligned or jammed, that there are no broken parts or other conditions that
could affect the operation of the machine. Whenever it is damaged, repair it before use.
•
Keep cutting instruments sharp and clean. Good maintenance of cutting tools reduces the likelihood of incidents
by making them easier to control. Keep the handles of this machine dry and clean. Greased or oiled handles are
slippery and cause loss of control over the machine.
•
If the machine starts to vibrate strangely, turn it off and examine it for the cause. If you do not see the reason,
take your machine to Technical Service. Vibrations are always a sign of a problem on the machine.
•
To transport the machine, remember to switch off the engine.
•
When transporting the machine: secure it properly to prevent it from tipping over, spilling fuel or becoming
damaged.
•
Store inactive tools out of the reach of children.
SERVICING
•
Have the machine checked periodically by a qualified technician using only original spare parts. If you have any
questions, please contact the Authorised Service Centre.
51
EN
Publicidad
