Correct Handling Of Machine; Points In Operation And How To Stop - Makita RBC2500 Manual De Empleo Y De Seguridad

CORRECT HANDLING OF MACHINE

Attachment of shoulder strap
– Adjust the strap length so that the cutter blade will be kept parallel with the
ground.
Detachment
– In an emergency, push the notches (1) at both sides, and you can detach the
machine from you.
Be extremely careful to maintain control of the machine at this time. Do not allow
the machine to be deflected toward you or anyone in the work vicinity.
WARNING: Failure to maintain complete control of the machine at all could result in
serious bodily injury or DEATH.

POINTS IN OPERATION AND HOW TO STOP

Observe the applicable accident prevention regulations.
Starting
Move at least 3 m away from the place of refuelling. Place the brush cutter on a
clean piece of ground taking care that the cutting tool does not come into contact
with the ground or any other objects.
Cold start
For machine with U Handle or Loop Handle
– Push the I-O switch (1) in the direction shown by the arrow.
– First place the machine on the ground.
– Give a gentle push on the primer pump (2) repeatedly (7 – 10 times) until fuel
comes into the primer pump.
– Push the choke lever (3) to the position "
– Firmly hold the clutch case by your left hand, as illustrated.
– Slowly pull the starter grip until resistance is felt and continue with a smart pull.
– Do not pull out the starter rope to its full extent and do not allow the starter handle
to be retracted without control, but ensure that it is retracted slowly.
– Repeat the starting operation until initial ignitions are heard.
– When the engine start, return the choke lever to "
lever will return to " "position automatically when the throttle lever is operated
and the throttle is opened.
".
". Please note that the choke
14
(1)
Hanger
(2)
(3)